Baler Control :: Industrial Electronic Repair

Links Menu

About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing


Part #:

Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info


tagged Comments
Baler Control

  Posted by Danny Tyson on Monday, January 12 2015

I have a JD 467 baler and the monitor works perfect for 40 to 50 rolls and then something seems to heat up in the monitor. The net wrap starts to mess up and won't cut the wrap. Sometime it will let the net start unrolling while baling and fill the bale with wraps of net. You can let it cool off for an hour and it will bale 30 to 40 before it acts up again. It is sending current to net wrap actuator and gets it hot. Dealer has come to the field each of the 3 previous years and gets it to work but it has cooled off I have learned. Every connection in wiring harness has been replaced by the dealership. I bought a new actuator and same results. My question is can you detect the problem on test bench when it takes a couple hours in the field to heat up or whatever makes it malfunction?

  Current thread:

Currently there are no responces to this post.

Suggested Tagged Message

View Tagged Message

Return Home
to Baler Control Repair

*Tagged Manufactures Baler Control

*Tagged List
Need to get your
Baler Control Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate

Contact Shop 1-336-969-0110

If you need your Baler Control unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of Baler Control units.

Reply to the Message Below!
OLD Topic: Repair of Baler Control Baler Control
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Comment about
Baler Control:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!

Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

  • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.

    Teijin Seiki Servo Drive
    Teijin Seiki

    NSK Servo Drive

    Etasis Power Supply

    Vickers Servo Drive Repair

    Nikki Denso Servo Drive Repair

    Board Repair

    Hosted by

    IERNC Created this page in 0.010704 seconds