Icon :: Industrial Electronic Repair

Links Menu

Home
About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Forum
Forum2
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing

Manufacture:

Part #:



Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info
1-336-969-0110

  
tagged Comments
Icon
  Posted by Jerry Raynor on Monday, August 12 2013

I recently received a treadmill from my son which had not been used in over 2 years and had been sitting in his garage. It did work the last time it was used. the PSB PN # is 132022. I set it up in my house, cleaned it, checked for broken or crimped wires, and turned it on. the unit ran slowly for about 5 seconds after pushing the start, then showed an "E2" error code. I removed the cover from the power units, and noted 2 steady red lights. When I reset and pushed start again, the light above PWM flickered, the unit ran slowly for about 5 seconds, then the same error code. The tach light never came on , by the way. I don't know much about IC boards, but tried to check continuity on some of the resistors. I got tone on some of them, but nothing on R4 and R8, as well as some others. I don't know if this means anything. I cleaned the board and all connections appeared good with no missing solder points or broken connections. Any thoughts or suggestions? Thanks. jr Oh, unit did not increase speed when increase was pushed.


  Current thread:

Currently there are no responces to this post.

Suggested Tagged Message

View Tagged Message

Return Home
to Icon Repair
*Tagged Manufactures Iconics Inc

*Tagged List
Need to get your
Iconics Inc Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate

Contact Shop 1-336-969-0110


If you need your Iconics Inc unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of Iconics Inc units.
Reply to the Message Below!
OLD Topic: Repair of Iconics Inc Icon
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Subject:
Comment about
Icon:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!
Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  


    • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.


    Teijin Seiki Servo Drive
    Teijin Seiki


    NSK Servo Drive
    NSK


    Etasis Power Supply
    Etasis



    Vickers Servo Drive Repair




    Nikki Denso Servo Drive Repair
    Board Repair
    Forum
    Parts



    Hosted by

    ABCDEFGHIJKLMNOPQRSTUVWXYZ
    IERNC Created this page in 0.100275 seconds