Axor :: Industrial Electronic Repair

Links Menu

Home
About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Forum
Forum2
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing

Manufacture:

Part #:



Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info
1-336-969-0110

  

tagged Comments
Axor

  Posted by Des Whitaker on Monday, June 25 2012

Can you please help me I have two of your drives (B17 C200 8/16 & 14/28) the 8/16 is my Y axis and the 14/28 is my X axis the CNC that is controlling them is Camsoft with a galil PC control card. How they are controlled is in Velocity Mode +/- 10v into the +Ref and with a jumper from the –Ref to GND on the Drive. The problem I am having is to get the two axes to do small round circles they are oval I am using a feed rate between 400 and 800 m/m per min. (a higher feed rate is needed).
I do have your manual I do know about the trimmer Adjustments (KV; DER; ACC; VEL; BIL) I have followed the book to get the drive’s back to factory settings as best as I can with No good result, can you please tell me which of the above would I have to a just to get the circles round and what else would I need to look for output volts input volts ext.
Please and thank you in advanced
Kind regards
Des Whitaker



  Current thread:

Currently there are no responces to this post.

Suggested Tagged Message

View Tagged Message

Return Home
to Axor Repair

*Tagged Manufactures Axor

*Tagged List
Need to get your
Axor Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate


Contact Shop 1-336-969-0110



If you need your Axor unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of Axor units.


Reply to the Message Below!
OLD Topic: Repair of Axor Axor
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Subject:
Comment about
Axor:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!

Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

  • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.


    Teijin Seiki Servo Drive
    Teijin Seiki



    NSK Servo Drive
    NSK


    Etasis Power Supply
    Etasis



    Vickers Servo Drive Repair




    Nikki Denso Servo Drive Repair

    Board Repair
    Forum
    Parts




    Hosted by

    ABCDEFGHIJKLMNOPQRSTUVWXYZ
    IERNC Created this page in 0.107203 seconds