Okuma machinery works :: Industrial Electronic Repair

Links Menu

Home
About Us
Repair Lab
Thermal Imaging
Manufacture's Repaired
Get Quote
Forum
Forum2
Repair Service Form
Credit Application Free Estimate Credit Application
Monitor Repair Monitor Repair
Power Supply Repair Power Supply Repair
Board Repair Board Repair

Get Repair Pricing

Manufacture:

Part #:



Contact Menu

Email Sales
Email Shop
Email Parts
Contact Info
1-336-969-0110

  

tagged Comments
Okuma machinery works

  Posted by Nicholas Micallef on Tuesday, February 1 2011

Dear Sirs, I have an OKUMA LB25 with an OSP5020L controller and an inverter (VAC-DRIVE UNIT TYPE A) OTHER MARKINGS ON THE INVERTER ARE D22-A, motor 15/11KW, LB25.

The problem with this inverter is that it is tripping when speed is reduced or electronic break is activated. Therefore it seems that some sort of back EMF or feedback is not working as it should. This defect started when we had a Voltage dip and the unit tripped. However if I reduce the speed gradually (manually) and then I stop the motor, this does not trip. When the speed is high or at a higher percentage, it will trip anyway. The only way to reset is either to switch off and on again or press the reset button on the inverter. When the fault occurs, the two RED LEDs (alarm A) flash.

Can you please guide us or a quick check, preferably to avoid sending parts and be without the lathe. We are an electronics R&D company and have the technical people and equipment and can easily follow your guide lines.

With great pleasure I send my regards.

Nicholas Micallef
R&D Development Technician.



  Current thread:

Currently there are no responces to this post.

Suggested Tagged Message

View Tagged Message

Return Home
to Okuma Machinery Works Repair

*Tagged Manufactures Okuma Machinery Works Ltd

*Tagged List
Need to get your
Okuma Machinery Works Ltd Repaired?
Quickly Hire our Service Dept
to do the work for you!

Credit Application Form
Free Estimate


Contact Shop 1-336-969-0110



If you need your Okuma Machinery Works Ltd unit tested or repaired
then give us a call at 1-336-969-0110.
We give fair estimates and offer a extended warranty on repairs of Okuma Machinery Works Ltd units.


Reply to the Message Below!
OLD Topic: Repair of Okuma Machinery Works Ltd Okuma machinery works
Your name:
Valid Email Address Required:
Phone Number:
Your Location:
Subject:
Comment about
Okuma machinery works:
You can contact us at 1-(336)-969-0110
We are open Monday to Saturday from 9am till 6pm EST
and yes the technicians & engineers work on Saturday!

Recent Questions

  • A   B   C   D   E   F   G   H   I   J   K   L   M  
  • N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

  • Disclaimer: This website is not sanctioned or approved by any manufacturer listed.
    "Industrial Electronic Repair" is not an authorized distributor or representative
    for the listed manufacturers or tradenames.


    Teijin Seiki Servo Drive
    Teijin Seiki



    NSK Servo Drive
    NSK


    Etasis Power Supply
    Etasis



    Vickers Servo Drive Repair




    Nikki Denso Servo Drive Repair

    Board Repair
    Forum
    Parts




    Hosted by

    ABCDEFGHIJKLMNOPQRSTUVWXYZ
    IERNC Created this page in 0.074865 seconds